реклама на салфетках, vrn.

10.18.4. Removal and installation of the control unit of a double-glazed window

It will be required to you: the screw-driver with a crosswise edge, a face key "on 10".
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove the right and left side facings of a tunnel of a floor (see. "Removal and installation of facings of a tunnel of a floor").
3. Wring out a clamp and disconnect serially three blocks of plaits of wires from the control unit of a double-glazed window.
4. Turn off on both sides on one nut of fastening of the control unit …
5. … also remove the block from the car.

Note
So the control unit of a double-glazed window combining functions of anticreeping system, an immobilizator and turning on of the light alarm system looks.
On the back party of the block the three-contact socket for connection of the additional sensor (blow or change of volume of salon) recommended by manufacturer of the car is located.
Pay attention to its marking that when replacing to buy the same block.