11.10.1. Removal and installation of a trunk lid

Good advice
Trunk lid quite heavy and bulky therefore it is recommended to remove and establish it together with the assistant.

It will be required to you: keys "on 10", "on 13", passatizh.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Disconnect a block of a plait of wires.
3. Squeeze a clamp of the holder of a plait of wires and take out the holder from an opening of the internal panel of a trunk lid.
4. Pull out the sealing plug of a plait from an opening in a trunk lid. Take a plait with a block from a trunk lid. If you are not going to replace a trunk lid, for assembly tie a thin wire or a rope to a block and only after that take a plait, having left a rope in a trunk lid. After that untie a rope from a plait.
5. Establish a suitable emphasis under a cover.
6. Unhook springs of both loops from arms on a body.
7. If you assume to establish an old cover, mark the provision of washers on cover loops. In this case after installation, most likely, it is not necessary to regulate the provision of a cover.
8. A key "on 13" turn off two nuts of fastening of loops to a cover on both sides (the assistant has to hold a cover) and remove a trunk lid.
9. The trunk lid can be removed together with loops. For this purpose a key "on 10" turn off nuts of fastening of axes of loops, holding axes from a provorachivaniye a key "on 13", take out axes and remove a trunk lid. When replacing remove all fittings from an old cover and establish on new.
10. Establish a cover as it should be, the return to removal. The provision of a cover is regulated at the expense of oval openings in loops. Without tightening finally a nut, accurately close a cover and, moving it, adjust the provision of a cover in an aperture. Gaps between back wings and a cover have to be uniform and identical. Then accurately open a cover and finally tighten nuts of its fastening.
11. Adjust the effort necessary for opening of a cover, shift of springs on one of the arms fixing teeths.