11.10.2. Removal and installation of the lock of a trunk lid and its drive

It will be required to you: keys "on 10", "on 13", face keys (head) "on 10", "on 13", screw-drivers with a flat and crosswise edge, passatizh.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Hook the screw-driver five percussion caps of fastening of facing of the lock …
3. … also remove facing.
4. Separate a block of a plait of wires of food of a motor-reducer of blocking of the lock.
5. Turn out two screws of fastening of a motor-reducer to the internal panel of a trunk lid.
6. Disconnect a motor-reducer rod from draft of the drive of the lock and remove a motor-reducer.
7. Remove draft.
8. Hook the screw-driver a tip of the draft going from the lock switch …
9. … also disconnect draft from the lock drive lever.
10. Hook the screw-driver draft …
11. … also disconnect it from the lock switch.
12. Shift to the left and remove a lock switch bracket.
13. Take out the lock switch from an opening in a trunk lid.
14. Weaken a draft fastening screw inhaling. Mark position of the lock on a trunk lid.
15. A face key "on 10" turn off three nuts of fastening of the lock …
16. … also remove the lock, having brought draft out of a lock drive lead.
17. A face key "on 10" turn off two nuts of fastening of the lever of the drive of the lock …
18. … also remove the lever.

Note
So the trunk lids removed from the car the lock and details of its drive look.

19. Before installation of the new lock grease its rubbing surfaces with jellied lubricant.
20. Establish the removed details as it should be, the return to removal.