You will need screw-drivers with a flat and crosswise edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Turn out two screws of fastening of the internal handle of a door with the module of management of window regulators and mirrors.	3. Take out the module from a door upholstery.

4. Release a clamp …	5. … also disconnect a block of a plait of wires from the module of management of window regulators and mirrors.

6. Turn out the screw of fastening of facing of the internal handle of a door …	7. … also remove facing.

8. Turn out three screws of fastening of an upholstery of a door.	9. Turn out the button of blocking of the lock of a door.

10. By means of the screw-driver wring out a door upholstery so that plastic holders left openings at doors, and remove an upholstery.

Useful tips Insert the screw-driver as it is possible closer to holders, otherwise it is possible to damage an upholstery. Not to scratch paint, wrap up a screw-driver sting an insulating tape.

Note The upholstery of a forward door (view from a reverse side) fastens to the door panel eight plastic holders. The damaged holders replace new.

11. Turn out two screws of fastening of an arm of the module of management of window regulators and mirrors …	12. … also remove an arm.

13. Remove big …	14. … and small noise-insulating laying.

15. Establish the removed details as it should be, the return to removal.