11.15.4. Removal and installation of facings of a tunnel of a floor

It will be required to you: a key "on 10", screw-drivers with a flat and crosswise edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Turn out screws of fastening of the left and right screen …
3. … also remove screens.
4. Turn out two screws of fastening of the top facing in a forward part (at the left and on the right).
5. Hook the screw-driver …
6. … also remove a cap.
7. Remove a cap in the center of dredging under a glass …
8. … also turn out the screw of fastening of the top facing.
9. Turn out four screws of fastening of the top facing to a floor.
10. Remove a box and a container of facing.
11. Turn out four screws of fastening of the top facing to an arm.
12. Hook the screw-driver …
13. … also remove a back ashtray.
14. Turn out two screws of fastening of the case of a back ashtray.
15. Turn out two screws of fastening of the top facing of a tunnel of a floor to the dashboard.
16. Remove a gear shifting lever cover from the top facing.
17. Turn a cover inside out and unwind an adhesive tape of fastening of a cover to the gear shifting lever.
18. Remove a cover from the gear shifting lever.
19. Disconnect blocks of a plait of wires from the button of opening of the lock of a luggage carrier and from the lighter …
20. … also remove the top facing of a tunnel of a floor.
21. Turn off four nuts of fastening of the lower facing to a floor …
22. … and two screws (at the left and on the right) fastenings of facing to an arm.
23. Hook the screw-driver …
24. … also remove from the lower facing the holder of a plait of wires.
25. Remove the lower facing of a tunnel of a floor.
26. Establish the removed details as it should be, the return to removal.