11.16.1. Removal and installation of the dashboard

Useful tips
Perhaps, at installation of the dashboard collars of fastening of plaits of wires as at dismantle of the panel in certain cases it is easier to cut them will be necessary for you.
Depending on a complete set of the car the different quantity of blocks with wires can be involved. Therefore at separation of blocks mark them relatively each other. It will facilitate work at installation of the dashboard. Mark free blocks separately.

It will be required to you: face keys "on 8", "on 10", screw-drivers with a flat and crosswise edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a steering wheel (see. "Removal and installation of a steering wheel").
3. Remove facing of a steering column (see. "Removal and installation of facing casings of a steering column").
4. Remove understeering switches (see. "Check and replacement of understeering switches").
5. Remove facings of a tunnel of a floor (see. "Removal and installation of facings of a tunnel of a floor").
6. Remove a combination of devices (see. "Removal and installation of a combination of devices").
7. Turn out screws of fastening of the central console of the dashboard on the right and at the left.
8. Having hooked the screw-driver …
9. … remove nozzles of heating of side glasses on the right and at the left.
10. A face key "on 10" turn off two nuts of the top fastening of the dashboard at the left and on the right.
11. Turn three clamps and uncover the block of safety locks and the relay.
12. Turn out four screws of fastening of the amplifier of the dashboard …
13. … also remove the amplifier.
14. Turn out at the left from below …
15. … and on the right from below two screws of fastening of the dashboard.
16. Turn out the screw of fastening of the dashboard to the left of a steering column …
17. … and the fastening screw which is on the right under the dashboard.
18. A key "on 8" turn out a bolt of fastening of "mass" wires of the dashboard to a body arm.
19. Shift clamps of blocks of a plait of wires of the dashboard to the right …
20. … also disconnect three blocks of a plait from the blocks established on an arm.
21. Separate a block of a plait of wires of the switch (lock) of ignition.
22. Disconnect blocks of a plait of wires from the electroamplifier of steering.
23. A key "on 10" turn off a nut of fastening of a "mass" wire of a plait of the dashboard from an arm of electronic blocks.
24. Shift a block clamp …
25. … also disconnect a dashboard plait from a plait of system of ignition.
26. Disconnect a dashboard plait block from the control unit of an electropackage.
27. Shift a clamp …
28. … also disconnect a dashboard plait block from the control unit of a safety cushion.
29. Remove the dashboard and take it from salon.

Note
As the dashboard quite bulky and heavy, this operation it is necessary to carry out with the assistant.

30. Install the dashboard as it should be, the return to removal.