11.16.2. Dismantling and assembly of the dashboard

You will need screw-drivers with a flat and crosswise edge.
1. Turn out three screws of fastening of the deflector of an obduv of a windshield …
2. … also remove the deflector.
3. Turn out two screws …
4. … also remove the left nozzle of system of ventilation and heating.
5. Similarly remove the right nozzle.
6. Hook the screw-driver and take out the switch of heating of back glass from an overlay of the console.
7. Disconnect a block of a plait of wires from the switch of heating of back glass.
8. Remove an ashtray.
9. Bring pins of a cover of a ware compartment out of openings of an overlay of the console and uncover.
10. Turn out four screws of fastening of an overlay of the console.
11. Hook the screw-driver …
12. … also take out a container from the dashboard (or remove the radio tape recorder if it is established).
13. Disconnect audio system plait blocks.
14. Turn out two screws of fastening of an overlay of the console located on each side windows under the radio tape recorder.
15. Remove an overlay of the console, overcoming resistance of spring holders in its top part.
16. Squeeze out from a reverse side …
17. … also remove the switch of the alarm system.
18. Press a clamp of a block of a plait of wires …
19. … also disconnect a block from the switch.
20. Disconnect blocks of a plait of wires of hours …
21. … from the heater electric motor switch …
22. … and from the control unit of a heater.
23. Wring out a clamp …
24. … also take out hours from an overlay of the console.
25. Turn out four screws of fastening of the control unit of a heater to an overlay of the console …
26. … also remove the block.
27. Turn out two screws of fastening of the central nozzle of system of ventilation to an overlay of the console.
28. Wring out four clamps from above …
29. … and four clamps from below from a nozzle …
30. … and then remove a nozzle.
31. Turn out the screw of fastening of the block of safety locks and the relay …
32. … also remove the block.
33. Disconnect a block of a plait of wires from the switch of illumination of a ware box.
34. Turn out the screw of fastening of the switch …
35. … also remove the switch.
36. Hook the screw-driver a plafond of illumination of a ware box and take out it from the dashboard.
37. Wring out a clamp and disconnect a block of a plait of wires from a plafond.
38. Turn out two screws of fastening of the left air duct of system of ventilation …
39. … also remove an air duct.
40. Similarly remove the right air duct.
41. Turn out two screws of fastening of a motor-reducer of the gate of distribution of an air stream, remove a motor-reducer …
42. … also disconnect a block of a plait of wires.
43. Turn out two screws of fastening of the air duct of heating of legs …
44. … also remove the air duct.
45. Turn out two screws of fastening of the distributor of airheating …
46. … also remove the distributor.
47. Collect the dashboard in the sequence, the return dismantling.