11:18. Replacement of a motionless glazing of a body

It will be required to you: the screw-driver, a pricker, a knife, set for an insert of glasses.
So set for an insert of glasses looks. It consists of a tuba with glue, a tip of a tuba, an activator/cleaner and soil.

Note
In instructions to sets of different producers there can be insignificant distinctions. In this regard when performing this operation be guided by the instruction to the set acquired by you.

Good advice
For removal of the pasted glass it is convenient to use a steel string.

1. Lower glasses of forward doors.
2. Remove facings of forward racks (see. "Removal and installation of facings of forward racks of a body").
3. Remove a cowl (see. "Removal and installation of a cowl").
4. Remove overlays of a frame of a windshield (see. "Removal and installation of overlays of a frame of a windshield").
5. Remove two adjusting wedges (one is shown, left).
6. Open a forward door and remove a door sealant from a windshield rack.
7. Hook the screw-driver edge of a side overlay of a windshield …
8. … also remove a slip.
9. Similarly remove the second slip.
10. Remove a windshield sealant, carefully clear it of dirt and sealant. If the sealant is damaged or lost elasticity, replace it.
11. Having slightly hooked glass the screw-driver, pierce a glue seam the pointed tool (for example, a pricker) and stretch a string in an opening.
12. For convenience of work on the ends of a string it is possible to fix screw-drivers which will serve as handles.
13. Saw a string a glue seam on all perimeter of glass (for performance of this operation the assistant can be required by you)...
14.... also remove glass from the car.

Prevention
Observe precautionary measures during the work with glass. If glass is damaged, it can unexpectedly collapse.

15. Cut off an old seam, leaving a thin layer of glue (1,0–2,0 mm).
16. Establish a sealant on new glass.
17. Put the activator...
18.... on the edge of glass I will also eat windows on all perimeter.
19. Apply soil on glass perimeter...
20.... and window aperture.

Prevention
You do not apply soil on the remains of old glue.

21. Evenly apply glue on a window aperture (thickness of a layer of 0,5 cm) and on glass perimeter.

Note
In the lower part of a frame of a windshield to a body two rubber slips preventing contact of glass with the acting body elements are pasted. Check their existence, otherwise new glass can be damaged.

22. Install glass assembled with a sealant on the car.
23. By means of adjusting wedges achieve uniform gaps between glass and an aperture on all perimeter of a window.
24. Press and record glass in any available way (for example, by means of a painting adhesive tape). The period of polymerization of glue makes not less than 2-3 h. During this time the car should not be exposed to any external influences. Even sharp closing of a door can lead to increase in pressure of air in salon and, as a result, to a glass separation. It is desirable to begin operation of the car after an insert of glass not earlier than in 24 h.
25. Replace back glass and glasses of a sidewall similarly.