11.7. Removal and installation of a forward wing

It will be required to you: keys "on 7", "on 8", "on 10".
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove the flap and the protection cover of a wing (see. "Removal and installation of the flap and protection cover of a wing").
3. Remove a decorative overlay of a threshold (see. "Removal and installation of decorative overlays of thresholds").
4. Remove a front bumper (see. "Removal and installation of a front bumper").
5. Shift the side repeater of the index of turn of a forward part of the car aside and take out it from a wing opening.
6. Wring out a clamp of a block of a plait of wires and disconnect a block from the repeater.
7. A key "on 8" turn out a bolt of forward fastening of a wing.
8. A key "on 8" turn out a bolt of the lower fastening of a wing.
9. Through a wheel niche a key "on 8" turn out two bolts of back fastening of a wing.
10. A key "on 8" turn out three bolts of fastening of a wing to a body and a bolt of the top fastening of a block headlight, and then remove a wing.
11. Establish a wing as it should be, the return to removal. It is recommended (especially at installation of a new wing) to smooth out the surfaces interfaced to a wing on a body and to establish new insulating laying between a body and the top flange of a wing, and also between a forward rack and a back flange of a wing. If there is no laying, it is possible to cover the interfaced surfaces with mastic.
12. Before a final inhaling of bolts of fastening expose a wing (at the expense of the increased openings), having provided identical and uniform gaps between a wing and the interfaced body panels. After installation of a new wing apply an anticorrosive covering on its internal surface.