11.9.4. Replacement of draft of the drive of the lock of a cowl

It will be required to you: a key "on 10", the screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a front bumper (see. "Removal and installation of a front bumper").
3. Mark the provision of washers concerning a body. It will facilitate further adjustment of position of the lock.
4. Turn out two bolts of fastening of the lock.
5. Having brought the lock out of an arm, unbend the end of draft of the drive of the lock. Bring the end of draft out of the metal plug and disconnect draft from the lock lever. Remove the metal plug from draft.
6. Shift a tip of a cover of draft and bring a cable out of a lock case cut.
7. Pay attention that on a tip of a cover of draft adjusting washers can be established.
8. Remove a draft cover tip.
9. Turn off a nut of fastening of the metal holder of a cover of a cable and remove the holder from a hairpin, and then from a draft cover.
10. Accurately press inside the plastic holder of a cover of draft and remove him from a draft cover.
11. Tie a soft wire or a rope which length is not less than length of thirst to the end of draft. It will facilitate work at installation of new draft.
12. From within salon remove the assembly block, press against the stop the handle of opening of a cowl and, having raised a cover tip up, bring a cable out of an arm cut (for descriptive reasons on a photo the dashboard is removed).
13. Disconnect a cable tip from the handle. For this purpose shift a cable in the G-shaped cut of the handle against the stop and remove it outside (for descriptive reasons on a photo the dashboard and the handle of opening of a cowl are removed).
14. Pull out a cable in salon so that the rope remained on the place of a cable. Untie a rope from a cable.
15. Establish a cowl lock drive cable as it should be, the return to removal except that holders of a cover of a cable it is necessary to fix in the last turn, after installation of the lock. Pay attention that the cable tip on the lever needs to be bent at the established cable cover tip in the lock case.