3.1.1. General methods of launch of the engine

Methods of launch of the injector engine are identical at any temperature of external air and liquid in the engine cooling system.
For start-up it is only enough to include a starter, without touching an accelerator pedal. The control system of the engine will independently set parameters of supply of fuel and an advancing of ignition, necessary for start-up.
1. Pull on yourself the cowl lock drive handle...
2.... wring out a hand a safety hook of a cowl and open a cowl.
3. Take out the masloizmeritelny probe …
4. … also check level oil level. It has to be between the top and lower levels of a mesh scale.
5. Check levels brake …
6. … and cooling liquids.

Fig. 3.1. Podkapotny space

7. Attentively examine the engine and podkapotny space (fig. 3.1, the decorative cover is for descriptive reasons removed). Pay attention on begin to flow gasoline, oil, the brake and cooling liquids. Be convinced of serviceability of an electrical wiring: check absence of damage of wires, reliability of connection of electric sockets of sensors of system of injection, other knots and details of electric equipment, an inhaling of plugs of the rechargeable battery, a starter and the generator, check reliability of connection of electric sockets of coils of ignition.

Note
Especially carefully check a condition of the socket of a plait of wires of the sensor of provision of a bent shaft. In the absence of contact in this socket launch of the engine will be impossible.

8. Without closing a cowl (in case of a rain or snowfall cover a cowl), you take the wheel.
9. Include ignition, having turned a key in the ignition switch situation "II" – will join an electrogasoline pump. For start-up include a starter, without touching an accelerator pedal. The system engine management will independently set parameters of supply of fuel and ignition, necessary for start-up.

Useful tips
It is better to close a cowl after the engine begins to work. Before it it is desirable to examine once again the engine, to be convinced of lack of leaks of fuel, oil, cooling liquid, and also foreign sounds in its work.
If for any reason during unsuccessful attempt of start-up spark plugs "are filled in", use the purges mode of cylinders. For this purpose press an accelerator pedal against the stop and include a starter. In this mode supply of fuel is absent and from cylinders a stream of fresh air excess gasoline is removed, at the same time spark plugs dry. After a purge repeat start-up attempt regularly.

If the engine was not started, there are three main reasons:
– the system of start-up does not work;
– the system of ignition does not work;
– the power supply system does not work.