4.5.8. Replacement of the filtering element of the air filter

Replace the filtering element of the air filter according to recommendations of manufacturer through each 30 000 km of a run. However its state depends on car service conditions: on more dusty and polluted roads the element gets littered quicker.

Good advice
Periodically between replacements take out the filtering element and clear it of dust, vigorously stirring up or blowing compressed air in the direction, the return to the movement of air during the operation of the engine.

You will need the screw-driver with a crosswise edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Turn out four screws of fastening of a cover of the air filter …
3. … wring out a clamp …
4. … also disconnect a block of a plait of wires from the sensor of a mass consumption of air.
5. Raise a cover, bending the airbringing sleeve a little …
6. … also take out the filtering element from a cover.
7. If it is necessary, remove dust and dirt from the case of the air filter.
8. Establish the new filtering element in a cover, having oriented the direction of his edges in the direction of an arrow.

Note
For an exception of a possibility of wrong installation of the filtering element from within the filter the inscription "Corrugations of the Filtering Element to Have along an Arrow" and an arrow are applied on a bottom of its case.

9. Establish all removed details as it should be, the return to removal.