5.11.4. Replacement of epiploons of camshafts

At detection of traces of leak of oil through epiploons of camshafts at first check whether the system of ventilation of a case is littered and whether its hoses are pressed, if necessary eliminate malfunctions. If the leak of oil does not stop, replace epiploons.
It will be required to you: all tools necessary for removal of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism and a tension roller"), and also a key "on 17", the device for fixing of camshafts from a provorachivaniye, the screw-driver with a flat edge, the hammer.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Install the piston of the 1st cylinder in the provision of VMT of a step of compression (see. "Installation of the piston of the first cylinder in the provision of VMT of a step of compression").
3. Take off a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism and tension roller").
4. Remove pulleys of camshafts (see. "Replacement of laying of a head of the block of cylinders").
5. Take out splines from flutes of camshafts.
6. Having hooked the screw-driver, take out epiploons.
7. Before installation of new epiploons examine working edges 1. They has to be equal, without vyryv, dents and flows of rubber. Springs of 2 epiploons have to be whole and unextended. Oil working edges engine.

Good advice
For simplification of a press fitting of epiploons execute small facets on their landing edges by means of a file or an emery circle.

8. Oil working edges of epiploons engine.
9. Establish epiploons by working edges in a block head, accurately fill workers an edge on camshafts by means of a wooden stick...
10.... also press against the stop by means of a suitable mandrel. As a mandrel it is possible to use a head of the suitable size from tool kit.
11. Establish all details as it should be, the return to removal. At the same time establish a pulley of the camshaft of inlet valves by the disk ensuring functioning of the sensor of phases to the engine. Similarly establish a pulley of the camshaft of final valves. Adjust a tension of a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism and a tension roller") and a generator drive belt (see. "Replacement of a belt of the drive of the generator").