5.11.5. Replacement of a forward epiploon of a bent shaft

At detection of traces of leak of oil through epiploons of a bent shaft at first check whether the system of ventilation of a case is littered and whether its hoses are pressed, if necessary eliminate malfunctions. If the leak of oil does not stop, replace epiploons.
Sign of need of replacement of a forward epiploon of a bent shaft is leak of oil through its edge. At the same time oil is sprayed by the rotating pulley of a bent shaft owing to what greasy are all forward part of the engine and a belt of the drive of the gas-distributing mechanism.
It will be required to you: all tools necessary for removal of a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism and a tension roller"), and also the screw-driver with a direct edge (two), the hammer.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Install the piston of the 1st cylinder in the provision of VMT of a step of compression (see. "Installation of the piston of the first cylinder in the provision of VMT of a step of compression").
3. Take off a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism and tension roller").
4. Having hooked two screw-drivers …
5. … remove the cogged pulley of a bent shaft.
6. Take out a spline from a flute of a shaft of a bent shaft.
7. Having hooked the screw-driver, take an epiploon from a cover of the oil pump.
8. Oil engine a working edge of a new epiploon, establish it in a cover of the oil pump, having oriented a working edge in the engine, and press an epiploon in a pump cover against the stop by means of a mandrel. As a mandrel it is possible to use a head of the suitable size from tool kit.
9. Establish all removed details and knots of the gas-distributing mechanism as it should be, the return to removal.
10. Adjust a tension of belts of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism and a tension roller") and a generator drive belt (see. "Replacement of a belt of the drive of the generator").