5.11.6. Replacement of a back epiploon of a bent shaft

Can be the reason of oiling of clutch plates to flow an epiploon of a main shaft of the transmission or a back epiploon of a bent shaft.
Motor and transmission oils differ on a smell. At a certain skill it is possible to determine by it, defective, what of epiploons.

Good advice
There is one more way of definition like oil. Drip oil in the water poured by a thin layer in capacity. Gearbox oil will spread on all water surface in the form of an iridescent film, and motor — will remain in the form of the drop similar to lentil grain.

It will be required to you: the screw-driver with a direct edge, a mandrel.
1. Remove the transmission (see. "Removal and installation of the transmission").
2. Remove coupling (see. "Removal and installation of coupling").
3. Remove a flywheel (see. "Removal, troubleshooting and installation of a flywheel").
4. Examine an epiploon. If it lost tightness, in its lower part will be visible began to flow oils.
5. Having hooked the screw-driver, take an epiploon.
6. Oil engine a working edge of a new epiploon, establish it in a nest of the block of cylinders, having oriented a working edge in the engine, and accurately fill a working edge on a neck of a bent shaft.
7. Press an epiploon in a nest against the stop, using a suitable mandrel.
8. Establish the removed knots as it should be, the return to removal.

Note
At installation of a flywheel grease a carving part of bolts of its fastening by structure for fixing of a carving of "Loktayt" or any with similar to it an anaerobic clamp of a carving.