5.11.8. Replacement of sealing rings of an inlet collector

For sealing of a joint between flanges of a head of the block of cylinders and an inlet collector, and also between flanges of throttle knot and an inlet collector in grooves of branch pipes of an inlet collector sealing rings are established. At violation of tightness of these rings the engine works unevenly ("troit").
It will be required to you: screw-drivers with a flat and crosswise edge, nippers or a knife, keys "on 10", "on 13".
1. Lift a cowl and disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a decorative casing of the engine (see. "Removal and installation of a decorative casing of the engine").
3. Remove throttle knot from an inlet collector (see. "Removal and installation of throttle knot").
4. Remove an inlet collector (see. "Replacement of laying of a cover of a head of the block of cylinders").
5. Remove sealing rings of inlet channels.
6. Hook the screw-driver …
7. … also remove a sealant of a flange of fastening of throttle knot.
8. Establish new sealing rings in collector grooves.
9. Before installation of an inlet collector close openings of inlet channels rags and clear seats of sealing rings.
10. Establish the removed details as it should be, the return to removal.