5.18.12. Replacement of a cable of the drive of a butterfly valve

If the butterfly valve not completely opens (the engine does not develop full capacity) or is closed (the raised idling turns), originally try to adjust a cable of the drive of a butterfly valve (see. "Check and adjustment of a cable of the drive of a butterfly valve"). If adjustment of the drive of a butterfly valve it is impossible to achieve full opening or closing of a butterfly valve or the drive jams, replace a drive cable.
It will be required to you: the screw-driver with a flat edge, passatizh with narrow sponges, bokoreza.
1. Remove a decorative casing of the engine (see. "Removal and installation of a decorative casing of the engine").
2. For replacement of a cable of the drive of a butterfly valve remove a safety bracket from the sector of throttle knot, having hooked it the screw-driver.
3. Take out a cable tip from a groove of the sector and disconnect a cable from throttle knot.
4. Remove a spring stopper …
5. … also bring a cable out of cuts of holders.
6. Release a cable, having had a bite bokorezam a plastic collar of fastening of a cable to a hose of ventilation of crankcase gases.
7. Shift a cable cover forward …
8. … also take from an opening in a front board a cable cover damper.
9. In interior of the car under the dashboard remove a cable tip from a pedal lever finger, having shifted it the screw-driver.
10. Take out a cable in a motor compartment.
11. Establish a cable as it should be, the return to removal. Do not forget to fix a cable by a new plastic collar on a hose of ventilation of crankcase gases.
12. Adjust the drive of a butterfly valve (see. "Check and adjustment of a cable of the drive of a butterfly valve").