5.7. Installation of the piston of the first cylinder in the provision of VMT of a step of compression

The piston of the 1st cylinder in situation TDP (top dead point) of a step of compression is installed in order that at work, the camshafts connected with removal of a belt of the drive, installation of phases of gas distribution was not broken. At violation of phases of gas distribution the engine will normally not work.
Expose compression step VMT on tags on pulleys of camshafts (at installation on tags on a flywheel or a pulley of a bent shaft in this situation there can be a piston of the either the 1st, or 4th cylinder). After that be surely convinced of coincidence of tags on a flywheel or on the cogged pulley of a bent shaft (if the generator drive pulley is removed). If at the same time the tag on a flywheel or a pulley of a bent shaft does not coincide, so installation of phases of gas distribution is broken (the piston of the 1st cylinder is not installed in VMT). In this case it is necessary to take off a belt of the drive of the camshaft and to turn a bent shaft before combination of tags.

Useful tips
As it is inconvenient to turn a bent shaft for a bolt of fastening to it of a pulley, it is possible to make it the next ways:
1) include any transfer (better the 4th) and slowly give a ride to the car before coincidence of tags on pulleys of camshafts with a tag on a back cover of a belt of the drive of camshafts;
2) include any transfer and you will hang out one of forward wheels. Then turn the hung-out wheel before coincidence of a tag on a camshaft pulley with a tag on a back cover of a belt of the drive of the camshaft.

On the engine of fashion. 21126 tags are applied on cogged pulleys of camshafts (ledges And) and a back cover of a belt of the drive of the camshaft (a cut of B).
Besides, tags are applied on a flywheel (risk) and a scale of a back guard of a case of coupling (a triangular cut). For descriptive reasons the transmission is removed.
In addition at all engines of a tag are applied on the cogged pulley of a bent shaft (point) and a cover of the oil pump (a triangular cut). These tags are visible only at the removed generator drive pulley.
It will be required to you: a cap key "on 17", a six-sided key "on 5", TORX T30 key, the screw-driver with a crosswise edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Turn out the screw-driver with a crosswise edge one screw of fastening of the right antisplash guard to the flap...
3. … TORX T30 key two screws of its fastening to a body …
4. … also remove a guard.
5. Open a cowl and a six-sided key "on 5" turn out five bolts of fastening of the top forward cover of a belt of the drive of the gas-distributing mechanism …
6. … also uncover.
7. A cap key "on 17" turn a bent shaft for a bolt of fastening of a generator drive pulley to it before coincidence of tags on pulleys of camshafts and a back cover.
8. Take out a cap from an opening in a case of coupling and check coincidence of tags on a flywheel (the thermostat is for descriptive reasons removed).