6.1.6. Replacement of a cable of the drive of switching off of coupling

It will be required to you: keys "on 8", "on 17", a caliper or a ruler.
1. In salon under the dashboard a key "on 8" turn off a nut of fastening of an emphasis of a cover of a cable to an arm of pedals and remove an emphasis from an arm.
2. Having hooked the screw-driver, remove a lock bracket and the case of the mechanism of compensation of wear of overlays of the conducted disk from a coupling pedal finger.
3. Remove the plastic plug from a pedal finger and examine it. Replace strongly worn out or damaged plug, having greased it before installation by Litol-24 or LSTs-15 lubricant.
4. In a motor compartment take from an opening in a front board a coupling switching off drive cable cover sealant.
5. Having pulled a cable tip in the direction of the movement of the car forward, bring a tip out of a coupling switching off fork groove.
6. A key "on 17" turn off a nut of fastening of a tip to an arm on the transmission, holding the second key a tip from a provorachivaniye …
7.... take out a tip from an arm and remove a cable from the car, extending it from an opening in a front board.
8. For installation of a new cable of the drive of switching off of coupling at first, having passed it in a front board opening, fix the wear compensation mechanism case on a coupling pedal finger.

Note
Before installation of the mechanism of compensation on a finger of a pedal apply LSTs-15 or Litol-24 lubricant on the finger plug.

9. Fix a cable cover emphasis on an arm of pedals.
10. Establish a cable cover sealant in a front board opening.
11. Establish a cable cover tip in an arm of the transmission and tighten a nut of its fastening.
12. Screw a lead on the lower tip of a cable, having provided a tip vystupaniye concerning a lead end face on 0–1 mm.
13. Establish a cable of the drive of switching off of coupling in a starting position for what move the lower tip of a cable against the stop forward in the direction of the movement of the car. Holding a tip in the extended situation, measure the size L between a fork and a lead, it has to make 27 mm. If the size does not correspond to the specified value, establish it by rotation of a lead in the necessary party.
14. Enter a cable tip into a groove of a fork of switching off of coupling and release — under the influence of a spring the lead of a tip has to be established on a fork without gap.

Note
Before installation of a lead of a tip on a fork apply on its surface contacting to a fork, LSTs-15 or Litol-24 lubricant.

15. Press a coupling pedal three times against the stop and repeatedly measure distance of L (see item 13). In case of need repeat adjustment.