6.2.10. Repair of the mechanism of the choice of transfers

Fig. 6.6. Mechanism of the choice of transfers: 1 – lever of the choice of transfers (forward course); 2 – the directing axis of blocking brackets; 3 – axis of the lever of the choice of transfers; 4, 11 – springs; 5 – lock ring; 6 – backing fork axis; 7, 12 – blocking brackets; 8 – fork of inclusion of a backing; 9 – lever of the choice of transfers (backing); 10 – case of the mechanism of the choice of transfers

The general view of the mechanism of the choice of transfers is shown in fig. 6.6.
It will be required to you: a key "on 10", the screw-driver with a flat edge.
1. Take out the mechanism of the choice of transfers from the transmission (see. "Dismantling of the transmission and troubleshooting of its details").
2. Remove a lock washer of the directing axis of blocking brackets.
3. Take out the directing axis.
4. Turn out a bolt of fastening of an axis of the lever of the choice of transfers (under a head of a bolt the spring washer is established).
5. Take out a lever axis.
6. Having hooked the screw-driver, remove a cylindrical spring.
7. Remove a plastic basic washer from a spring.
8. Remove the block of levers...
9.... and a conic spring with basic washers.
10. Remove a lock washer from an axis of a fork of inclusion of a backing.
11. Remove a fork of inclusion of a backing from the case of the mechanism of the choice of transfers.
12. Check a condition of levers of the choice of transfers forward and a backing and blocking brackets. If these details are worn-out, damaged or deformed, replace them assembled.
13. Replace worn-out axes of levers.
14. Replace the bent, broken or sunk springs.
15. Replace the worn-out, damaged or deformed fork of inclusion of a backing.
16. Collect the mechanism of the choice of transfers as it should be, the return to dismantling, having oiled previously all rubbing parts gearbox. At the same time the conic spring with basic washers is established by the party of bigger diameter to the mechanism case.
17. In order that it is easier to get a fastening bolt to a carving opening of an axis of the lever of the choice of transfers, at an end face of an axis it is executed special vents under the screw-driver.