7.1.3. Removal and installation of a telescopic rack

It will be required to you: keys "on 13", "on 17", "on 19".
1. Slow down the car the parking brake and establish an antiretractable emphasis ("boots") under back wheels. Raise a jack a forward part of the car and establish it on support. Remove a wheel.
2. In a niche of a wheel take out a brake hose from an arm on a rack.
3. Disconnect steering draft from the rotary lever (see. "Removal and installation of an external tip of steering draft and protective cover of the spherical hinge").
4. Apply tags on an eccentric washer and a rack, having marked with that the provision of an adjusting bolt concerning a rack. It will help to keep approximately disorder of wheels at installation of a rack.
5. Turn off a nut of an adjusting (top) bolt of fastening of a rack to a rotary fist and remove a bolt together with an eccentric washer.
6. Similarly turn off a nut of the lower bolt of fastening of a rack to a rotary fist and take out a bolt.
7. Disconnect a rotary fist from a rack.
8. In podkapotny space turn off three nuts of the top fastening of a rack …
9. … also remove a telescopic rack through a wheel niche.
10. Establish a telescopic rack as it should be, the return to removal. At installation of an old rack wrap an eccentric washer according to earlier made tags and, holding an adjusting bolt in this situation from a provorachivaniye, tighten a fastening nut.
11. Having installed the car on wheels, check reliability of an inhaling of a nut of fastening of the top support of a rack. Upon termination of assembly check and if necessary adjust a convergence and disorder of wheels.