8.3.2. Removal and installation of the electromechanical amplifier of steering

It will be required to you: the screw-driver with a crosswise edge, keys "on 8", "on 13" (two), a face key "on 13".
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a steering wheel (see. "Removal and installation of a steering wheel").
3. Turn counterclockwise on 90 ° three locks of a cover of the block of safety locks, having released its lower part …
4. … also uncover the block of safety locks.
5. Remove understeering switches (see. "Check and replacement of understeering switches").
6. Turn out four screws of fastening of the amplifier of the dashboard …
7. … also remove the amplifier.
8. Disconnect a block of a plait of wires from a connector of understeering switches.
9. Wring out a clamp …
10. … also separate blocks of a plait of power wires of the lock of ignition.
11. Separate blocks of a plait of wires of the reading-out immobilizator coil.
12. Wring out a clamp …
13. … also disconnect a block of a plait of wires from the socket of the control unit of the electromechanical amplifier of steering.
14. Similarly disconnect the second block of a plait of wires from the control unit.
15. Turn off a nut of a coupling bolt of the cardan hinge of the electromechanical amplifier from the driveshaft of the steering mechanism and remove a bolt.
16. Turn off two top nuts of fastening of the electromechanical amplifier to a body, turn off two lower nuts on 3–4 turns …
17. … also remove the electromechanical amplifier from the car.

Note
So the steering shaft removed from the car assembled looks.

18. Weaken fastening of a collar of a connector of understeering switches …
19. … also remove a connector.
20. Turn out the screw of fastening of the protection cover …
21. … also remove a casing.
22. Wring out a clamp …
23. … also disconnect a block of a plait of wires from the control unit of the electromechanical amplifier of steering.
24. Similarly disconnect the second block of a plait of wires from the control unit.
25. Turn out two screws of fastening of the control unit to an arm of the electromechanical amplifier of steering …
26. … also remove the control unit.

Note
So the control unit of the electromechanical amplifier of steering looks. Pay attention to its marking that when replacing to buy the similar block.

27. Establish the electromechanical amplifier of steering as it should be, the return to removal.

Note
If at adjustment on height the steering wheel is badly fixed in a standard position, tighten a clamp hairpin nut.