8.3.3. Removal and installation of the driveshaft of steering

It will be required to you: the screw-driver with a flat edge, a key "on 13" (two).
1. Turn off a nut …
2. … also take a bolt of the collar fastening the top and lower hinges.
3. Mark position of the cardan hinge on a shaft of the electromechanical amplifier …
4. … turn off a nut of a bolt of a collar of the cardan hinge and take out a bolt from a collar.
5. Bring the driveshaft out of the hinge …
6. … also shift the hinge from a shlitsevy shaft of the electromechanical amplifier.
7. Mark position of the driveshaft on a driving gear wheel …
8. … turn off a nut …
9. … also take a bolt from a fastening collar.
10. Move apart a collar the screw-driver …
11. … also remove the driveshaft from a driving gear wheel of the steering mechanism.

Note
So the cardan hinge 1 and the driveshaft 2 with the hinge look.

12. Install the driveshaft as it should be, the return to removal.