9.10.1. Replacement of brake hoses of forward brake mechanisms

It will be required to you: a special key "on 10" for an otvorachivaniye of nuts of brake tubes, a key "on 15".
1. Remove the corresponding wheel.
2. A key "on 10" turn off a brake tube from a hose, holding the second key "on 15" a hose tip. At "souring" of a nut of fastening of a tube cut a hose and turn off a hose tip from a tube.
3. Take out a hose tip from an arm on a body.
4. Take out a sealant of a brake hose from an arm on a rack.
5. A key "on 15" turn out a hose tip from the wheel cylinder …
6. … also remove a brake hose.

Note
Pay attention that on a tip of a brake hose the copper sealing ring is established. Replace a ring at installation of a hose.

7. Establish a new hose as it should be, the return to removal. You watch that it was not overwound. For control along a hose the color strip is put.
8. Pump over a hydraulic actuator of the brake system (see. "Pumping of a hydraulic actuator of the brake system").