9.4. Removal and installation of the vacuum amplifier of brakes

It will be required to you: keys "on 10", "on 13", screw-drivers with a flat and crosswise edge.
1. Remove overlays of a frame of a windshield (see. "Removal and installation of overlays of a frame of a windshield").
2. Remove a noise-insulating upholstery of a motor compartment (see. "Removal and installation of a noise-insulating upholstery of a motor compartment").
3. A key "on 13" turn off two nuts of fastening of the main brake cylinder to the vacuum amplifier.
4. Without bending and without overwinding brake tubes, accurately take the main brake cylinder aside.
5. Disconnect from the vacuum amplifier a vacuum hose together with the valve.
6. Under the dashboard a key "on 13" turn off four nuts of fastening of an arm of a pedal of a brake.
7. Remove an arm with a pedal and the vacuum amplifier (in podkapotny space).
8. Having hooked the screw-driver, remove a lock plate of a finger and, having pushed out a finger, disconnect a pusher of the vacuum amplifier from a pedal.
9. A key "on 13" turn off two nuts of fastening of the amplifier to an arm of a pedal and, having hooked the screw-driver, remove the amplifier from an arm.

Note
So the vacuum amplifier of brakes removed from the car looks. For its replacement get a detail with the same marking.

10. Establish the vacuum amplifier upside-down, apply sealant on the surface of contact of the vacuum amplifier with a pedal arm.