9.6.1. Removal and installation of a tank of the main brake cylinder

The tank is removed for replacement or preventive washing. Besides, sometimes there is a need to remove a tank for replacement of rubber plugs of its fastening.
It will be required to you: a key "on 10", screw-drivers with a flat and crosswise edge.
1. Remove overlays of a frame of a windshield (see. "Removal and installation of overlays of a frame of a windshield").
2. Remove a noise-insulating upholstery of a motor compartment (see. "Removal and installation of a noise-insulating upholstery of a motor compartment").
3. Uncover a tank with a level sensor float.
4. Pump out from a tank a rubber pear or the syringe brake fluid.
5. Take away tank clamps...
6.... hook a tank the screw-driver and remove it from the main brake cylinder.
7. Examine rubber plugs of fastening of a tank. Replace the plugs torn, cracked or lost elasticity.

Note
So the tank of the main brake cylinder removed from the car looks.

8. Install a tank in the sequence, the return to removal.