9.6.2. Removal and installation of the main brake cylinder
It will be required to you: keys "on 10", "on 13", screw-drivers with a flat and crosswise edge …
… and also a special key "on 13" for an otvorachivaniye of brake tubes.
1. Remove overlays of a frame of a windshield (see. "Removal and installation of overlays of a frame of a windshield").
2. Remove a noise-insulating upholstery of a motor compartment (see. "Removal and installation of a noise-insulating upholstery of a motor compartment").
3. Pump out a rubber pear or the syringe brake fluid from a tank of the main brake cylinder (see. "Removal and installation of a tank of the main brake cylinder").
4. A key for an otvorachivaniye of brake tubes turn off two nuts of fastening of brake tubes to the main brake cylinder …
|
5.... disconnect brake tubes from the cylinder and take them aside. Consider that after that from the main cylinder a little liquid therefore enclose a rag under the cylinder will flow out. Muffle openings in brake tubes.
|
6. If necessary remove a tank of the main brake cylinder (see. "Removal and installation of a tank of the main brake cylinder").
7. A key "on 13" turn off two nuts of fastening of the cylinder to the case of the vacuum amplifier...
|
8.... also remove the cylinder.
|
9. Install the main brake cylinder upside-down. Pay attention to a condition of a rubber sealing ring, at emergence on it of cracks or signs of aging replace a ring.
10. Pump over a hydraulic actuator of the brake system (see. "Pumping of a hydraulic actuator of the brake system").